>> ART Pro Audio: Products / USB Phono Plus - Phono Preamp with USB

*** Windows 7 Users - Please read this FAQ ***

ARTcessories™ is proud to introduce the USB Phono Plus – a high quality USB audio interface with a standalone Phono preamplifier.

The USB Phono Plus, (Formerly named the “USB Micro•PRE”) acts as an interface between your computer and a wide variety of analog and digital sources. The analog inputs are switchable between Phono and Line level signals and a low cut filter removes rumble and wind noise while leaving the audio pristine. The front gain trim control and signal/clip LED allow you to optimize the A/D for a wide range of input sources. The front panel USB monitor/headphone jack and the optical output on the rear panel can monitor audio output from your computer. The built-in low noise Phono preamp circuit is highly accurate and precisely conforms to the RIAA standard. The Line Output jacks are always connected to the input preamps signal for source monitoring.

Housed in an all aluminum black anodized case, the USB Phono Plus can be powered by either an external power source or directly off the USB port so remote recording is a snap. Optical TOSLINK inputs and outputs as well as S/PDIF inputs let you use the USB Phono Plus as a digital audio to USB interface as well. The USB Phono Plus is fully compliant with the USB 1.1 specification and uses USB adaptive mode for playback and USB asynchronous mode for record. It will work with the USB audio device drivers built into Windows 98SE/ME/2000/XP or Macs with native USB support OS9.1 or greater or OSX. No special drivers are needed.

    SOFTWARE DOWNLOADS:
  • Go to download page for "Audacity"
    (For use with PC, MAC and LINUX)
  • Go to download page for "AudioGrabber"
    (For use with PC only)
  • USB Phono Plus Software
    Patch for Apple OSX "Tiger"
    Download Audacity Patch 1.2.4rc2
  • Download Update Notes
  • View Update Notes as HTML

    • Features

    • Frequency Response: 10Hz –50KHz, +/-.5dB
    • THD: .01% Typical @ 1KHz
    • Hum and Noise: >90dB below clipping
    • Input Impedance: 47k Ohms/100pF (phono) 270k Ohm (line)
    • Maximum Input Level: 40mVrms @1KHz (phono), +19dBu (line)
    • Maximum Gain: 45dB @ 1KHz (phono), +6dB (line)
    • Analog Output Connections: RCA (preamp line output), 1/8” (USB monitor/headphone output)
    • Maximum Output Level: +6dBu (1.4Vrms)
    • Filter Type/Response: Switchable, High Pass, -3dB @ 22Hz
    • A/D & D/A: 16 bit, 44.1KHz or 48KHz USB selectable
    • Digital Audio Interface: TOSLINK in and out, S/PDIF coax (RCA) in
    • Computer Interface: USB 1.1 compliant, Windows 98SE/ME/2000/XP or newer Mac OS9.1 or newer
    • Power Requirements: 7-12V DC or 9-12V AC @ 150mA, or USB buss powered
    • Dimensions: 1.75”H x 4.2”W x 3.5”D (44.5mm x 107mm x 89mm)
    • Weight: 1.35 lbs. (.61kg)

    Discontinued Products Series Overview

    ART has a long history of creating innovative, great sounding audio processors. Check here for information on discontinued ART gear. There's a lot of great processors out there that are nearly twenty years old and still rockin!

    If you are searching for a product that does not appear in this section contact us at ART Customer Support Thank you.